93450C CK3 kit won't 0x72

This site is best viewed in a modern browser with JavaScript enabled.

crazyfrengy

I'm having some troubles getting the lite-on into 0x72 mode. I have gotten it into 0x52, 0xD2, and 0x80 and I've tried 2 resistors so far. Any ideas? I'm pretty sure I made the cuts deep enough.

Tutoromix

This might help:
http://www.tiaowiki.com/forums/xbox-360-hardware-talk/how-to-read-and-dump-key/

crazyfrengy

My computer freezes when it tries to detect any 360 drive, even with the pins to the two points.

Tutoromix

Try to turn on the CK3 (keep the SATA cables plugged in) only after the computer has booted up fully and into Windows.
If it freezes as soon as you launch Dosflash, then give your computer one more restart (preferably turn it off/on) and then it should stop freezing after relaunching Windows/Dosflash.

crazyfrengy

I put it back together. I'll try again on the weekend.

crazyfrengy

I got the VIA card and I used DOSFLASH in windows. Turns out I didn't cut the traces deep enough. I did it again and it worked great. Showed up as valid firmware in JungleFlasher. The kit worked like a charm!