"Unknown or NO Flash Chip Detected"

This site is best viewed in a modern browser with JavaScript enabled.

"Unknown or NO Flash Chip Detected"

x0a

Hey everyone. I have a bricked WRT320n. I flashed a bad CFE (wrong MAC address). I have the original CFE and I want to flash it back, but it seems that zjtag has trouble recognizing my flash chip (mx25l6405dmi-12g).
It seems it isn't listed in /showflashlist. So how the heck are people jtagging this router?
If I use the /fc:107 tag (I have no clue how similar this flash chip is to mine, other than its the same brand and 8mb), I'm able to backup my CFE and NVRAM. But I can't flash. It gets stuck at "Erasing block: 1 (addr = 1C000000)."
Please point me in the right direction. Tell me I didn't toss all this money for nothing

PS C:\Users\st0rm\Desktop\zjtag.source_1.8> ./zjtag -probeonly /cable:3 /L1:5 /nocwd
==============================================
zJTAG EJTAG Debrick Utility v1.8 RC3
==============================================
cableid=3, cabletype=0
Dev 0:
Flags=0x2
Type=0x8
ID=0x4038a99
LocId=0x41
SerialNumber=TITL0411
Description=USB Multi-Protocol Adapter Lite
ftHandle=0x0
Set I/O speed to 5000 KHz
USB TAP device has been initialized. Please confirm VREF signal connected!
Press any key to continue... ONCE target board is powered on!
Detected IR chain length = 0
There are 1 device(s) in the JTAG chain
IDCODE for device 1 is 0x1471617F (IR length:0)
Probing bus ... Done
Defined IR Length is 5 bits
CPU assumed running under LITTLE endian
CPU Chip ID: 00010100011100010110000101111111 (0x1471617F)
*** Found a Broadcom manufactured BCM4716 REV 01 CPU ***
- EJTAG IMPCODE ....... : 00000000000000000000000000010011 (0x00000013)
- EJTAG Version ....... : 1 or 2.0
- EJTAG DMA Support ... : Yes
- EJTAG Implementation flags: R4k MIPS64
Issuing Processor / Peripheral Reset ... Done
Enabling Memory Writes ... Done
Halting Processor ... <Processor did NOT enter Debug Mode!> ... Done
Clearing Watchdog ... Skipped
Loading CPU Configuration Code ... Skipped
Probing Flash at Address: 0x1FC00000 ...
Detected Chip ID (VenIDevID = 001A : 0000)
*** Unknown or NO Flash Chip Detected ***
*** REQUESTED OPERATION IS COMPLETE ***