Hey guys just got the Tiao and having an issue writing.
Zjtag version: v1.7 R4
Cable: Tiao MP
target: Motorola 5101
file: 32k Custom(Nonvol)
able to flash detect no problem
Dev 0:
Flags=0x2
Type=0x6
ID=0x4038a98
LocId=0x251
SerialNumber=TM00896A
Description=TIAO USB Multi-Protocol Adapter A
ftHandle=0x0
Set I/O speed to 1000 KHz
USB TAP device has been initialized. Please confirm VREF signal connected!
Press any key to continue... ONCE target board is powered on!
Detected IR chain length = 5
Probing bus ... Done
Defined IR chain Length is 5 bits
CPU assumed running under BIG endian
CPU Chip ID: 00000011001101001001000101111111 (0334917F)
*** Found a Broadcom manufactured BCM3349 REV 01 CPU ***
- EJTAG IMPCODE ....... : 00000000100000000000100100000100 (00800904)
- EJTAG Version ....... : 1 or 2.0
- EJTAG DMA Support ... : Yes
- EJTAG Implementation flags: R4k MIPS32
Issuing Processor / Peripheral Reset ... Skipped
Enabling Memory Writes ... Done
Halting Processor ... Skipped
Clearing Watchdog ... Done
Loading CPU Configuration Code ... Skipped
Probing Flash at Address: 0x1FC00000 ...
Detected Chip ID (VenID
evID = 0089 : 88C3)
*** Found a CFI Compatiable Flash Chip from Intel
on win Xp - dma write not correctly !! finishes writing but takes 5+ minutes to write a 32k file
on Win 7 - dma write not correctly !! finishes writing 32k file in 20 seconds
used drivers from website, properly configured vid and pid
I am able to flash no problem with Blackcat cable 40 secs no errors
thanks for any help
