Hi,
I purchase a TUMPA to debrick my ASUS RT-N16,
it can probe the cpu, but can detect the flash.
is there any suggestion?
C:\Documents and Settings\teddy\zjtag-1.8\zjtag.source_1.8>zjtag.exe -probe
only /L1:3
==============================================
zJTAG EJTAG Debrick Utility v1.8 RC3
==============================================
Dev 0:
Flags=0x2
Type=0x6
ID=0x4038a98
LocId=0x211
SerialNumber=TIX2WCKKA
Description=TIAO USB Multi-Protocol Adapter A
ftHandle=0x0
Set I/O speed to 7500 KHz
USB TAP device has been initialized. Please confirm VREF signal connected!
Press any key to continue... ONCE target board is powered on!
Detected IR chain length = 0
There are 1 device(s) in the JTAG chain
IDCODE for device 1 is 0x1471617F (IR length:0)
Probing bus ... Done
Defined IR Length is 5 bits
CPU assumed running under LITTLE endian
CPU Chip ID: 00010100011100010110000101111111 (0x1471617F)
*** Found a Broadcom manufactured BCM4716 REV 01 CPU ***
- EJTAG IMPCODE ....... : 00000000000000000000000000010011 (0x00000013)
- EJTAG Version ....... : 1 or 2.0
- EJTAG DMA Support ... : Yes
- EJTAG Implementation flags: R4k MIPS64
Issuing Processor / Peripheral Reset ... Done
Enabling Memory Writes ... Done
Halting Processor ... <Processor did NOT enter Debug Mode!> ... Done
Clearing Watchdog ... Done
Loading CPU Configuration Code ... Skipped
Probing Flash at Address: 0x1FC00000 ...
Detected Chip ID (VenID:DevID = 001A : 0000)
*** Unknown or NO Flash Chip Detected ***
*** REQUESTED OPERATION IS COMPLETE ***
Thanks,
Teddy
