zJTAG is not finding my flash.
C:\Users\Travis\Downloads\zjtag-0.4\zjtag>zjtag.exe -probeonly /L1:4
==============================================
TUMPA EJTAG Debrick Utility V0.4
==============================================
Set I/O speed to 6000 KHz
USB TAP device has been initialized. Please confirm VREF signal connected!
Press any key to continue... ONCE target board is powered on!
Probing bus ... Done
Detected IR Length is 8
CPU assumed running under LITTLE endian
CPU Chip ID: 10010100011100000100000101111111 (9470417F)
*** Found a Broadcom manufactured BCM4704 REV 09 CPU ***
- EJTAG IMPCODE ....... : 00000000100000000000100100000100 (00800904)
- EJTAG Version ....... : 1 or 2.0
- EJTAG DMA Support ... : Yes
- EJTAG Implementation flags: R4k MIPS32
Issuing Processor / Peripheral Reset ... Done
Enabling Memory Writes ... Done
Halting Processor ... <Processor Entered Debug Mode!> ... Done
Clearing Watchdog ... Done
Loading CPU Configuration Code ... Skipped
Probing Flash at Address: 0x1FC00000 ...
Detected Chip ID (VenID:DevID = 0017 : 1000)
*** Unknown or NO Flash Chip Detected ***
*** REQUESTED OPERATION IS COMPLETE ***
I am using the TUMPA.
The flash ID is EON EN29LV320AB-70TCP.
Can we have this flash chip added to supported chips? Thanks.