kan4club
I have a Samsung drive with 1.61 loaded on it. I am trying to take it back to stock so I can load the lates dashboard and then load lt 1.91. JF is not detecting the drive. Everything is hooked up correctly. The eject button on the kit extracts the drive and then press the eject button again to close the drive half way and swith the kit off. I wait a few seconds and turn the kit back on, but my computer is not detecting the drive. I checked the webiste forums and tutorials, but all reference Benq, hitachi, or lite-on drives. Any assistance will be greatly appreciated. Thanks
lilpup
kan,
if you remember which port it use to show up on, select that port and hit intro/device id,and follow what it says to do. should get to status 0x72 (also known as vendor mode for you sammy. you can then read the drives firmware, or load up stock and write it to the drive.
just make sure drive is powered and connected to pc b4 hitting into/device id.
also sammy drives are not like hitachi drives (for getting the drive into mode b/vendor mode) for ms25 and drive is displayed on port,simply hit into. for ms28 and displayed on port,simply hit sammy unlock.
lilpup