One of these two:
1: try to save to a different location, such as c:\
2: Did you do this "Once the status is 0x72, you can read the key... but before you ready the firmware, you will need to disconnect the pogo pin from point A (black one, connect to GND via resistor), but make sure you still keep point B connected to 3.3V: " ? This is mentioned in the tutorial. If you need to read the firmware, you need to disconnect pogo pin from point A.
boiboi3 wrote:
I keep getting this error message when I try to read my firmware. I am using 20ohms
Manufacturer ID: 0xC2
Device ID: 0x11
Flash Name: MXIC(MX25L2005)
Flash Size: 262144 bytes
Getting Status from port 0xA400
Serial flash found with Status 0x72
Reading Bank 0: ................
Reading Bank 1: ................
Reading Bank 2: ................
Reading Bank 3: ................
Lite-On Dump file saved to C:\my document\JungleFlasher v0.1.69 Beta (75)\JungleFlasher v0.1.69 Beta (75)\Lite-OFW.bin
Loading firmware from buffer
Parse Failed !
I kept my dvd drive off. hit intro, then turn dvd drive on with ground. Then once I get the 0x72 I press read and it asks me to save and then it gives me this error.
I tried on 1.67B, 1.69B and dosflash 1.8 and they all are not reading my firmware. Please advise on what I can do to fix this. I have tried this a bunch of times.
I am using the solderless procedure and I have cut my PCB properly. It is not reading my DVD drive as 7XXXX when I try to read the DVD drive. I am also using Nforce motherboard.
I am not sure what the problem is.
Is it my resister?