Universal JTAG configuration

This site is best viewed in a modern browser with JavaScript enabled.

Universal JTAG configuration

Solace

Not really specific to the TJTAG but i see no other forums to ask in regards to this piece of hardware made by TIAO. They currently have guides on how to configure the cable for numerous scenarios, unfortunately what i am trying to achieve is a USB jtag nt cable configuration to achieve a successful flash of a sb5102 through SPI
JTAG connector of USB JTAG NT SPI connector of J303
Pin 1(TRST) Pin 9(ISP enable)
Pin 3(TDI) Pin 10(SI)
Pin 5(TDO) Pin 8(SO)
Pin 9(TCK) Pin 6(SCK)
Pin 11(RESET) Pin 4 (CS)
Pin 2(GND) Pin 2(GND)
I have achieved pins 3 5 9 and 2 so far. but i am unable to figure out how to configure TRST and RESET "RST?"

[deleted]

"USB JTAG NT" is not a TIAO product. Please use their forums for support.
If you are using TUMPA, please see: http://www.tiaowiki.com/w/TIAO_USB_Multi_Protocol_Adapter_User%27s_Manual