Getting burned out

This site is best viewed in a modern browser with JavaScript enabled.

jackandjill

Hi i have sucessfully created a spoof firmware using the solderless kit and the tutorial provided, i got till the part that u have asked me to paste the silver paste and let it dry i let it dry and then when i am using iprep i noticed that i need to know the sata port later on so i connected the whole board again and opened dosflash and to my surprise i saw a little tiny minie spark at the point B(3.3V) so i smy board spoilt forever?? i have no choice? because when i tested it for continuity my multimeter still beeps which means good i even tested the point from B to A to see the connectivity and yes it exists...
So my problem did i lost my PCB board? if not i am getting error when using iPrep it says cant load firware even though i am trying to load the spoofed firmware, how to resolve this?Finally, does more silver paste on the board makes it better? please advice your loyal customer thanks... :-[

Tutoromix

I can tell you what to do to repair it. You probably shorted the entire PCB or didn't let it dry fully, but that can be easily fixed. I have some more tips here - http://www.tiaowiki.com/forums/xbox-360-hardware-talk/how-to-read-and-dump-key/
Post a high quality/high resolution screenshot of the PCB where the pads are, and I will edit it. The PCB board can still be brought back to life. There are specific points where the multimeter shouldn't beep. Link: http://www.tiaowiki.com/forums/xbox-360-hardware-talk/83850c-v2-cutting-the-pcb-and-using-the-conductive-glue/msg680/#msg680