Make sure your connections are correct before launching JungleFlasher, as well as your CK3 resistor connections. Make sure the needle is touching the correct points properly, especially the GROUND/black wire.
If this doesn't help, you need to cut one of the Point A/B traces you didn't think you cut properly. Make sure you cut both the dark/light-green lines on the motherboard as shown in the Tiaowiki tutorial. Try making sure though you keep getting Status 0x72 until at least 10 tries in DosFlash.
Also try using a
20ohm resistor. Below is where the pogo pin needles must touch after you have finished fixing some of the traces.
