Build a simple JP1 cable

From TIAO's Wiki
Revision as of 12:22, 27 September 2009 by Admin (talk | contribs) (→‎Parts List)
Jump to: navigation, search

10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!

USBJP123.small.JPG DG-JP12-02_small.jpg DG-JP1-U02_small.jpg DG-JP1-P02_small.jpg ext_small.jpg pl2303.small.JPG

Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com


Parts List

  1. 4 feet of flat ribbon cable
  2. DB25 Housing with Grommet, scews and wire holders
  3. DB25 connector
  4. 1.0k resistor X 2 (necessary for Kameleon and other remotes)
  5. 1N5818 schottky diode works for both desktops and laptops
  6. 6 pin female IDC connector to fit your remote (with strain relief)
  7. 6 pin male header
Parts List

Let's make it

  1. Familiar with all the components. none|thumb|Parts
  2. Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture. imgfeed_015.jpg|none|thumb|

USBJP123.small.JPG DG-JP12-02_small.jpg DG-JP1-U02_small.jpg DG-JP1-P02_small.jpg ext_small.jpg pl2303.small.JPG

Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com



10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
Retrieved from "http://tiaowiki.com/wiki/index.php?title=Build_a_simple_JP1_cable&oldid=633"