Difference between revisions of "Build a simple JP1 cable"
From TIAO's Wiki
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
(→Parts List) |
(→Let's make it) |
||
| Line 21: | Line 21: | ||
== Let's make it == | == Let's make it == | ||
| − | # Familiar with all the components. [[ | + | # Familiar with all the components. [[Image:Imgfeed_035.jpg|none|thumb|Parts]] |
# Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture. [[Image|imgfeed_015.jpg|none|thumb|]] | # Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture. [[Image|imgfeed_015.jpg|none|thumb|]] | ||
Revision as of 12:23, 27 September 2009
Contents
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
Parts List
- 4 feet of flat ribbon cable
- DB25 Housing with Grommet, scews and wire holders
- DB25 connector
- 1.0k resistor X 2 (necessary for Kameleon and other remotes)
- 1N5818 schottky diode works for both desktops and laptops
- 6 pin female IDC connector to fit your remote (with strain relief)
- 6 pin male header
Let's make it
- Familiar with all the components.
- Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture. imgfeed_015.jpg|none|thumb|
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
