Difference between revisions of "Build a simple JP1 cable"
From TIAO's Wiki
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
(→Let's make it) |
(→Let's make it) |
||
| Line 22: | Line 22: | ||
== Let's make it == | == Let's make it == | ||
# Familiar with all the components. [[Image:Imgfeed_035.jpg|none|thumb|Parts]] | # Familiar with all the components. [[Image:Imgfeed_035.jpg|none|thumb|Parts]] | ||
| − | # Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture. [[Image | + | # Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture. [[Image:imgfeed_015.jpg|none|thumb|]] |
<span class="plainlinks"> | <span class="plainlinks"> | ||
Revision as of 12:23, 27 September 2009
Contents
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
Parts List
- 4 feet of flat ribbon cable
- DB25 Housing with Grommet, scews and wire holders
- DB25 connector
- 1.0k resistor X 2 (necessary for Kameleon and other remotes)
- 1N5818 schottky diode works for both desktops and laptops
- 6 pin female IDC connector to fit your remote (with strain relief)
- 6 pin male header
Let's make it
- Familiar with all the components.
- Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture.
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
