Difference between revisions of "Build a simple JP1 cable"
From TIAO's Wiki
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
(→What do you need to spoof the firmware) |
(→Parts List) |
||
| Line 20: | Line 20: | ||
[[Image:JP1-P01.gif|none|thumb|Parts List]] | [[Image:JP1-P01.gif|none|thumb|Parts List]] | ||
| − | + | == Let's make it == | |
| + | # Familiar with all the components. [[Images:Imgfeed_035.jpg|none|thumb|Parts]] | ||
| + | # Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture. [[Image|imgfeed_015.jpg|none|thumb|]] | ||
<span class="plainlinks"> | <span class="plainlinks"> | ||
Revision as of 12:22, 27 September 2009
Contents
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
Parts List
- 4 feet of flat ribbon cable
- DB25 Housing with Grommet, scews and wire holders
- DB25 connector
- 1.0k resistor X 2 (necessary for Kameleon and other remotes)
- 1N5818 schottky diode works for both desktops and laptops
- 6 pin female IDC connector to fit your remote (with strain relief)
- 6 pin male header
Let's make it
- Familiar with all the components. none|thumb|Parts
- Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture. imgfeed_015.jpg|none|thumb|
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
