Difference between revisions of "Build a simple JP1 cable"
From TIAO's Wiki
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
(→What do you need to spoof the firmware) |
(→What do you need to spoof the firmware) |
||
| Line 9: | Line 9: | ||
| − | == | + | == Parts List == |
# 4 feet of flat ribbon cable | # 4 feet of flat ribbon cable | ||
| Line 18: | Line 18: | ||
# 6 pin female IDC connector to fit your remote (with strain relief) | # 6 pin female IDC connector to fit your remote (with strain relief) | ||
# 6 pin male header | # 6 pin male header | ||
| + | [[Image:JP1-P01.gif|none|thumb|Parts List]] | ||
| + | |||
Revision as of 12:18, 27 September 2009
Contents
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
Parts List
- 4 feet of flat ribbon cable
- DB25 Housing with Grommet, scews and wire holders
- DB25 connector
- 1.0k resistor X 2 (necessary for Kameleon and other remotes)
- 1N5818 schottky diode works for both desktops and laptops
- 6 pin female IDC connector to fit your remote (with strain relief)
- 6 pin male header
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
