Difference between revisions of "Build a simple JP1 cable"
From TIAO's Wiki
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
(→What do you need to spoof the firmware) |
|||
| Line 10: | Line 10: | ||
== What do you need to spoof the firmware == | == What do you need to spoof the firmware == | ||
| + | |||
| + | # 4 feet of flat ribbon cable | ||
| + | # DB25 Housing with Grommet, scews and wire holders | ||
| + | # DB25 connector | ||
| + | # 1.0k resistor X 2 (necessary for Kameleon and other remotes) | ||
| + | # 1N5818 schottky diode works for both desktops and laptops | ||
| + | # 6 pin female IDC connector to fit your remote (with strain relief) | ||
| + | # 6 pin male header | ||
Revision as of 12:15, 27 September 2009
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
What do you need to spoof the firmware
- 4 feet of flat ribbon cable
- DB25 Housing with Grommet, scews and wire holders
- DB25 connector
- 1.0k resistor X 2 (necessary for Kameleon and other remotes)
- 1N5818 schottky diode works for both desktops and laptops
- 6 pin female IDC connector to fit your remote (with strain relief)
- 6 pin male header
Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
